Published 19 November 2026 at 07:01
Most people in the workshop or quality department will recognize this: Two colleagues measure the same cylinder bore with a two-point internal measuring instrument and each gets a different number. The difference is a few hundredths of a millimeter, but it is enough for one person to reject a workpiece and the other to approve it. The cause is rarely the instrument. It is that the measuring head sits slightly tilted in the hole, or that it has not been guided all the way to the bore’s largest diameter.
What it is
A three-point internal micrometer has three measuring contacts positioned 120° apart around the instrument’s axis. When you turn the instrument, the three contacts open simultaneously and settle against the bore wall. The instrument centers itself, and it is the geometry itself that ensures the measurement is taken perpendicular to the bore axis. This digital instrument covers Ø100-150 mm, has a resolution of 0.001 mm and a stated accuracy of ±0.005 mm. The measuring faces are made of carbide and wear slowly, even with daily use.
What problems it solves
The biggest benefit is that the operator’s influence is reduced. You do not have to “rock” the instrument to find the largest dimension, as you do with a two-point instrument. You zero it on a setting ring at nominal diameter, guide the head into the bore, turn until all three contacts are firmly in contact, and read the value. The display can switch between mm and inches and between ABS and INC, and the preset and reset functions make it easy to read the deviation from nominal size directly. With an extension, the measuring head can reach down to 1100 mm, so deep bores do not require special tools.
Where it is used
Typical applications are precision measurement of machined housings and cylinders. These include:
Hydraulics: Incoming inspection of cylinder tubes and valve housings, where the bore diameter determines whether the seal works. If you measure at several depths and rotations, you can also see taper and form deviations.
Engine and compressor: Inspection of cylinder liners during overhaul. Here you can compare the measurements with the nominal size and see how much wear there is before deciding on honing or replacement.
Calibration laboratory and QC: Traceable bore measurement, where it is important that two different people get the same result on the same workpiece.
Why it pays off
The instrument costs around DKK 8,000, but the calculation is rarely about the purchase. Every time a workpiece is rejected or reworked because of a doubtful measurement, it costs machine time and material. Every time a delivery is disputed with the customer because the measurements do not match, it costs time in the quality department. With a self-centering instrument, fewer measurements are repeated, and fewer good workpieces are rejected. The aluminum case with extension and a V357 battery means the instrument is ready for use and protected when not in use. Remember to check the instrument against the setting ring at regular intervals so that traceability is maintained.
If you regularly measure bores between 100 and 150 mm, this instrument is worth a closer look.